The table below shows whether body of X6 E71, made from 2015 to 2016, is galvanized and the quality of processing. Print
Car body condition
• immersion in zinc electrolyte under current • zinc layer 9 - 15 microns • includes a share of aluminum body elements • protection of connections against electrochemical corrosion has been applied • introduction of plasma welding (WIG) and rations of seams • Semi-hollow punch-riveting have been used since 2015
Result of processing: Good Car's 8 years old.Considering the car's age and quality of the zinc processing, under normal operating conditions the first corrosion will begin in 6 years.
• immersion in zinc electrolyte under current • zinc layer 9 - 15 microns • includes a share of aluminum body elements • protection of connections against electrochemical corrosion has been applied
Result of processing: Good Car's 7 years old.Considering the car's age and quality of the zinc processing, under normal operating conditions the first corrosion will begin in 7 years.
The information in table is collected from open sources and may contain errors.About sources
Full-body — the car body is fully processed, including hidden and hard-to-reach cavities.
Partial — all nodal points and most vulnerable parts of the car body, thresholds, bottom, bottom of the doors are processed.
Nodal points processing — includes only processing of welding places, fasteners, stamping and other small parts.
Over years the processing is changed. The younger car the better it's galvanized!
Hot-dip Galvanizing — best method (high corrosion resistance, resistance to mechanical influences, partial regeneration).
Electroplating — good method (less corrosion resistance that matches perfectly with the paint and primer).
Zincrometal — acceptable method (metal with an elastic coating on a zinc base, low anti-corrosion properties, low resistance to mechanical influences).
Cold Galvanizing — bad method (anaphoretic soil with an admixture of zinc is not able to resist corrosion).
Steel with a protective coating based on zinc - zincrometal, it contains three components:
1 — zincrometal (zinc solution in epoxy resin) 10-20 microns
2 — dacromet (zinc variance inchromic acid water solution) 2-5 microns
3 — sheet of steel
The presence of zinc particles in ground covering the car body does not affect it's protection and is used by the manufacturer for word "Zinc Coated" in advertising.
Test results of cars that came off the conveyor with the same damage (cross) on the bottom of front right door are presented below. The tests were carried out in laboratory. Conditions in a chamber with hot salt fog for 40 days correspond to 5 years of normal operation.
Car with Hot-dip Galvanizing (zinc layer 12 - 15 microns)